@jonaskane I scale up a bunch of 28mm scatter terrain / misc, without problem.
You can use a combination of Blender, Fusion, Mesh Mixer and PrusaSlicer to tweak the models as needed. Plenty of Youtube University courses available.
@flexion-dynamo Ah, I've never tried messing around with Blender, etc. I just tried to upscale in Lychee by estimating (i.e., a 2ft mace on a 6 inch figure should be about 2in long...but then the handle or some other proportion is off). Maybe I'll take a look.
@jonaskane In that case start with PrusaSlicer. I never have much problem adjusting size with that.
I started resin printing 2 years ago. Adapted a lot of heads from statues for figures. Now I'm getting to the big stuff: Batmobiles!
Thats nice. Jupiter is 2nd on my buy list.
Resin: Cobra Podium Classified Scale
Finally got around to printing the TPU tracks for the Polar Battle Bear. Working on my new paint work station setup, so this is done for now.
HISS Tank Army in progress.
@flexion-dynamo
You're 3D printing H.I.S.S. tanks?
I expect that you'll be walking in to a room full of friends and family members conducting an intervention any day now.
@flexion-dynamo
You're 3D printing H.I.S.S. tanks?
I expect that you'll be walking in to a room full of friends and family members conducting an intervention any day now.
They won't get past the HISS Tanks
@flexion-dynamo
You're 3D printing H.I.S.S. tanks?
I expect that you'll be walking in to a room full of friends and family members conducting an intervention any day now.They won't get past the HISS Tanks
This exchange WINS the entire Fwoosh!! Thanks for the laugh, guys! Been a stressful week, so that was much-needed.
Latest Post: Avatar the Last Airbender Our newest member: Count von Curdles Recent Posts Unread Posts
